|
|
|
|
Pinhole Detector - DTU-6 for Diathermy Instruments
FEATURES:
| Simple test techniques |
No special skills to be acquired |
| Non-destructive test procedures |
No damage to instruments from test systems |
| Fault indication by audible or visual signal |
Reproducible results |
| Isolated from electrical mains |
Technical support from a British manufacturer |
| Accurate system settings |
Maintenance programme and re-callibration service available (where appropriate). |
| Fully supported by manufacturer/distributor |
Compatible with Quality/Health & Safety initiatives |
| Compatible with ISO Standard and CE marked |
|
| |
| |
|
|
|
|
|
The DTU-6 is the device of choice for ensuring the the insulation on diathermy instruments is intact and the instrument will not pose a hazard to either an operator or a patient. The device is powered by a re-chargable battery. No special technique is required and audible and visual indicators confirm fault detection. The testing procedure itself will not damage instuments being tested.
DTU-6 Detector
Battery, earth lead, built-in charger
Mains lead,drum brush electrode
Hospital test base
Test leads
Instruction manual
|
|
|
|
Continuity Tester - CT9v for Diathermy Cables
The CT9v will detect open circuit faults on diathermy Leads with 4mm plug ends or hook ends; an adapter is available for testing leads with Bovey 8mm plug ends.
The Continuity Tester is supplied complete with a PP3 9V battery and full operating instructions.
|
|
|
|
|
|
